Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unwrap the power cord from the handle.
-
Remove the 56.0 mm Phillips head #2 screw located above the water tank cap.
-
Pull the handle to separate it from the body.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the three 12.0 mm Phillips head #2 screws where the handle connects to the body.
-
Remove the plastic cap.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the three 16.0 mm T10 Torx screws near the top of the body and remove the water tank cap.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove steam control button cover with a metal spudger.
-
Remove the two 12.0 mm Phillips head #2 screws underneath.
-
Remove the plastic rim with clear plastic cover.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the Shark logo decal on the front of body using a metal spudger.
-
Remove the two 12.0 mm Phillips head #2 screws underneath.
-
Pull out the plastic cover to remove.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pop off the grey front plate to expose the control panel and screws necessary to open mop body.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the three 12.0 mm Philips head #2 screws connected to the dark grey plastic trim.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the four 16.0 mm T10 Torx screws located on the back of the mop.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two 12.0 mm Phillips head #2 screws that hold the power cord to the device.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pop open the white plastic mop body by pulling apart from the front and back side.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the four 12.0 mm Phillips head #2 screws on top of the electric valve.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove both plastic pieces holding the electric valve in place.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift electric valve out of place and tilt to the side to expose and remove the two 12.0 mm Phillips head #2 screws on the side.
-
Annulla: non ho completato questa guida.
Altre 2 persone hanno completato questa guida.