Salta al contenuto principale

Shark Flex DuoClean Power Cord Replacement

Cosa ti serve

  1. Shark Flex DuoClean Power Cord Replacement, Dust Cup: passo 1, immagine 1 di 2 Shark Flex DuoClean Power Cord Replacement, Dust Cup: passo 1, immagine 2 di 2
    • Squeeze Dust Cup release buttons on either side of the component.

    • Pull up to release Dust Cup.

  2. Shark Flex DuoClean Power Cord Replacement, Power Cord: passo 2, immagine 1 di 2 Shark Flex DuoClean Power Cord Replacement, Power Cord: passo 2, immagine 2 di 2
    • Remove the pre-motor filter with your hands.

  3. Shark Flex DuoClean Power Cord Replacement: passo 3, immagine 1 di 1
    • Remove the post-motor filter.

  4. Shark Flex DuoClean Power Cord Replacement: passo 4, immagine 1 di 1
    • Remove the two 15 mm screws by twisting counterclockwise with the T10 Torx screwdriver.

  5. Shark Flex DuoClean Power Cord Replacement: passo 5, immagine 1 di 2 Shark Flex DuoClean Power Cord Replacement: passo 5, immagine 2 di 2
    • Remove the two 12 mm screws by twisting counterclockwise with the T15 Torx screwdriver.

    • To fully remove the power cord, cut the wires using a wire cutter.

    • For reassembly, use the soldering guide in the Introduction.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

caoimhe

Membro da: 10/08/18

979 Reputazione

4 Guide realizzate

Team

Cal Poly, Team S17-G5, White Fall 2018 Membro di Cal Poly, Team S17-G5, White Fall 2018

CPSU-WHITE-F18S17G5

4 Membri

14 Guide realizzate

Un commento

I found with further dissasembly, uncrimping and recrimping the wiring loom saved having to add more connections.

qwazew - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 10

Tutti i Tempi: 1,375