Introduzione

This guide will show you how to take apart the fan to remove the Printed Circuit Board.

Parti

Nessuna parte richiesta.

  1. Use a Philips #2 screwdriver to unscrew the four 6mm Phillips #0 back screws.
    • Use a Philips #2 screwdriver to unscrew the four 6mm Phillips #0 back screws.

    • Do this by unscrewing from left-to-right then pull the screws out of the back of the fan

    Aggiungi Commento

  2. Pull the front and back cover apart.
    • Pull the front and back cover apart.

    • Be careful not to pull the front cover off completely because it holds the wires.

    Aggiungi Commento

  3. Diffondi allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    Diffondi allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    • Remove the Phillips (5-mm head) 6-mm screw that holds the circuit board to the outer shell of the fan.

    • Make sure the fan is unplugged while removing the circuit board as you may get shocked.

    • To remove the screws, unscrew in a left-to-right fashion at an angle to make sure that the wires do not get tangled.

    Aggiungi Commento

    • Remove the top cover containing the circuit board and the wires by pulling it away from the body of the fan.

    Aggiungi Commento

    • Remove the circuit board from the top cover. Do not touch the other side of the circuit board as you may damage circuit elements.

    • Unscrew the four screws on the top of the circuit board in a left-to-right fashion. After pull screws out of the board.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Mateo Begue

Membro da: 26/09/2012

78 Reputazione

2 Guide realizzate

Team

Cal Poly, Team 15-46, Forte Fall 2012 Membro di Cal Poly, Team 15-46, Forte Fall 2012

CPSU-FORTE-F12S15G46

5 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 9

Tutti i Tempi: 887