Salta al contenuto principale

Sega Master System Model 2 Disassembly

Cosa ti serve

Panoramica Video

  1. Sega Master System Model 2 Disassembly, The Case: passo 1, immagine 1 di 1
    • Take out the 5 screws at the bottom

  2. Sega Master System Model 2 Disassembly, RF Shield: passo 2, immagine 1 di 1
    • Remove the 5 screws (3 at the back and 2 on the front)

    • Remove the screw at the side (this screws is different then the other 5 so remember to put them away from the other 5 screws since they are similar)

    • This screw is for the rf shield under for the voltage regulator under this bigger rf shield, its not needed to remove that screw

  3. Sega Master System Model 2 Disassembly, Cartridge Slot: passo 3, immagine 1 di 1
    • Remove the 2 screws thats holding the cartridge slot down

  4. Sega Master System Model 2 Disassembly, The End: passo 4, immagine 1 di 1
    • Congratulations! You have opened your Sega Master System Model 2!

Conclusione

To reassemble your device, follow these instructions in reverse order.

Screenshots taken from a video by Global Garage

Altre 3 persone hanno completato questa guida.

Krisow

Membro da: 10/18/17

605 Reputazione

2 Guide realizzate

3 Commenti

This is in the wrong section.

Owen Ready - Replica

Nope, its in the Sega Master System area.

Krisow -

Not a Master System

Chad Luciano - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 9

Ultimi 30 Giorni: 45

Tutti i Tempi: 2,298