Introduzione

This repair guide wil give a walk through on how to replace the power LED in a Sega Genesis.

Parti

Nessuna parte richiesta.

Remove the six screws from the underside of the console with a Phillips #1 screwdriver.
  • Remove the six screws from the underside of the console with a Phillips #1 screwdriver.

Aggiungi Commento

Flip the Sega Genesis upright.
  • Flip the Sega Genesis upright.

Aggiungi Commento

Gently lift the top casing.
  • Gently lift the top casing.

  • Note: the case will be connected to the main board by LED wires.

Aggiungi Commento

Bend out the LED leads into vertical positions.
  • Bend out the LED leads into vertical positions.

Aggiungi Commento

Slide the LED wire apparatus off the lead pins.
  • Slide the LED wire apparatus off the lead pins.

  • Note: observe which color wire corresponds with which length of pin.

Aggiungi Commento

Separate the main board from the outer case.
  • Separate the main board from the outer case.

Aggiungi Commento

Remove plastic "Power / On" cover by pushing tabs together.
  • Remove plastic "Power / On" cover by pushing tabs together.

Aggiungi Commento

Pull "Power / On" cover away from the console cover.
  • Pull "Power / On" cover away from the console cover.

Aggiungi Commento

From the outside of the top cover, remove LED.
  • From the outside of the top cover, remove LED.

Aggiungi Commento

Insert new LED (Click here to buy LED.)

Aggiungi Commento

Re-insert "Power / On" cover until it clicks into place.
  • Re-insert "Power / On" cover until it clicks into place.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 5 persone hanno completato questa guida.

Anthony Porchia

Membro da: 11/10/2010

341 Reputazione

1 Guida realizzata

Team

Cal Poly, Team 3-29, Regan Fall 2010 Membro di Cal Poly, Team 3-29, Regan Fall 2010

CPSU-REGAN-F10S3G29

4 Membri

5 Guide realizzate

My LED won't turn on when I turn on the machine though when I took it out and touched it on a battery it lit up. Did I put it back in wrong or what?

Brandon - Replica

Long leg on the LED goes to the red wire.

Short leg to the white wire. If that's not the case, you may have burned the LED or the spot doesn't work anymore.

Last attempt would be getting your +V5 from the resistor below as shown in this image.

http://i.imgur.com/TucGEXj.jpg

Thunder....16

PIero Bogani -

The model I am trying to change the led on is the 1601 HD graphics Genesis. The problem I have is there are NO simple easy press tabs to pop off the red ring. What is the correct way to remove the LED on this model? Thank you for your time.

snoopydaturd - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 19

Ultimi 30 Giorni: 132

Tutti i Tempi: 10,724