Menü

Le tue impostazioni

Il mio banco da lavoro

Ottieni un rapido accesso alle guide, ai componenti e alle risposte per i tuoi dispositivi
Il Mio Carrello

Sembra che il tuo carrello sia vuoto

Sfoglia il Nostro Negozio

Sega Game Gear Headphone Jack/Volume Wheel Replacement

Scritto Da: Brandon Page (e 6 altri collaboratori)
  • Commenti: 0
  • Preferiti: 3

Difficoltà

Moderato

Passi

8

Tempo Necessario

Suggerisci un tempo??

Sezioni

3

Contrassegni

0

Introduzione

Guide to replace the small logic board that contains the 3.5mm headphone jack as well as the volume wheel.

Strumenti

Acquista questi strumenti

Parti

Nessuna parte specificata.

  1. Place your device upside down and locate the two battery compartments.

    • Place your device upside down and locate the two battery compartments.

    Traduci

  2. Press on the tabs at the bottom of the battery covers then lift up to remove.

    • Press on the tabs at the bottom of the battery covers then lift up to remove.

    • Remove batteries if they are present.

    Traduci

  3. Remove the following screws:

    • Remove the following screws:

    • Seven Phillips scres

    • One 4.5 mm Gamebit screw

    Traduci

  4. Kit di riparazione batterie iPhone

    Solo $29.99

    Buy Now

    Kit di riparazione batterie iPhone

    Solo $29.99

    Buy Now

  5. Use tweezers to take all other screws out.

    • Use tweezers to take all other screws out.

    Traduci

  6. Gently open the case by unfolding it over the top of the Sega Game Gear. Do not pull the back of the case away, as cables are connected between both sides.

    • Gently open the case by unfolding it over the top of the Sega Game Gear.

    • Do not pull the back of the case away, as cables are connected between both sides.

    Traduci

  7. Carefully unplug the 2 white-tipped connectors on the top cover. Carefully unplug the 2 white-tipped connectors on the top cover. Carefully unplug the 2 white-tipped connectors on the top cover.

    • Carefully unplug the 2 white-tipped connectors on the top cover.

    Traduci

  8. Unscrew the screws to remove the metal covering. Unscrew the screws to remove the metal covering.

    • Unscrew the screws to remove the metal covering.

    Traduci

  9. The screws that need to be removed are missing from this picture.

    • The screws that need to be removed are missing from this picture.

    • Remove the two screws from the highlighted locations.

    Traduci
Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

con 6 altri collaboratori

Brandon Page

Membro da: 15/04/2010

130 Reputazione

2 Guide realizzate

Distintivi: 9

+6 altri distintivi

Team

Cal Poly, Team 28-33, Regan Spring 2010 Membro di Cal Poly, Team 28-33, Regan Spring 2010

CPSU-REGAN-S10S28G33

5 Membri

6 Guide realizzate

0 Commenti

Aggiungi un commento

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 3

Ultimi 7 Giorni: 5

Ultimi 30 Giorni: 18

Tutti i Tempi: 5,817