Parti

Nessuna parte richiesta.

  1. Using a Phillips head screwdriver remove  six screws from the bottom of the console.
    • Using a Phillips head screwdriver remove six screws from the bottom of the console.

      • The six screws are marked.

    Aggiungi Commento

  2. Remove the two screws that attach the Genesis' connector to the rest of the console.
    • Remove the two screws that attach the Genesis' connector to the rest of the console.

      • The two screws are marked in the diagram.

    Aggiungi Commento

    • Slide the lock tab to the left to separate the halves of the console.

    Aggiungi Commento

    • Lift from the left side to remove the top of the case.

    Aggiungi Commento

    • Using the spudger, pry the cover off of the Genesis attachment.

    Aggiungi Commento

  3. Spedizione gratuita per ordini superiori a $20
    Usa il codice BLUEANDBLACK al checkout
    Spedizione gratuita per ordini superiori a $20
    Usa il codice BLUEANDBLACK
    • Lift the top of the case to remove the cover.

    Aggiungi Commento

    • Remove the faceplate by pulling it up, then out.

    Aggiungi Commento

    • Remove metal plate by unscrewing the three screws with the Phillips head screwdriver and then lifting the plate.

      • The three screws are shown on the diagram.

    Aggiungi Commento

    • Remove the two screws from the plastic bar.

      • The two screws are shown pictured.

    Aggiungi Commento

    • To remove the CD tray

      • Remove the four screws with the Phillips head screwdriver.

    Aggiungi Commento

    • Carefully unplug the wire connected to optical reader.

    Aggiungi Commento

    • Remove the four screws on the underside of the CD tray with a small Phillips head screwdriver.

      • The four screws are highlighted on the diagram.

    • The four springs below the circuit board are attached to the screws, so be careful not to lose them when you remove the screws.

    Aggiungi Commento

    • Carefully remove the CD tray from circuit board.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

sskyllin

Membro da: 18/10/2010

21 Reputazione

2 Guide realizzate

Team

Cal Poly, Team 5-14, Maness Fall 2010 Membro di Cal Poly, Team 5-14, Maness Fall 2010

CPSU-MANESS-F10S5G14

5 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 2

Ultimi 7 Giorni: 11

Ultimi 30 Giorni: 32

Tutti i Tempi: 6,915