Place the monitor face down.
  • Place the monitor face down.

  • Remove the four 11.5mm screws with a #2 Phillips screwdriver.

  • Remove the stand by pulling it out.

Aggiungi Commento

Remove two 11.5mm screws with a  #2 Phillips screwdriver.
  • Remove two 11.5mm screws with a #2 Phillips screwdriver.

  • Remove the plastic bar.

Aggiungi Commento

  • Using a #2 Phillips screwdriver, remove the six 7mm screws at the circled locations.

Aggiungi Commento

  • Pry the monitor using the plastic opening tool to release the clips holding the cover on.

    • There are four clips on each side, four on the top, and one on the bottom.

    • You may hear a loud snapping noise when releasing the clips. Do not be alarmed, it is natural.

  • Once all the clips have been released, remove the cover by pulling it up.

Aggiungi Commento

  • Using the #2 Phillips screwdriver, remove the one 6mm screw.

  • Unplug the indicated cable by pulling on the base.

  • Slide the cover toward the top of the monitor.

  • Remove the cover.

Aggiungi Commento

  • Use caution when removing the connectors as they can easily break when removing.

  • Disconnect the multi-pin connector at the top of the board by firmly grasping the connector and pulling to the side.

  • Disconnect the multi-pin connector that runs between the video motherboard and the power supply motherboard. Firmly grasp the connector and pull straight up.

  • A plastic opening tool can be used to assist in the removal of connectors.

Aggiungi Commento

  • Remove the two 3/16" hex head screws from the VGA connecter. Use a pair of needle nose pliers if a wrench is not available.

Aggiungi Commento

  • Remove the four 6.4mm #2 Phillips screws from the corners of the motherboard with a #2 Phillips screwdriver.

Aggiungi Commento

  • Lift the motherboard straight up to remove it from the back panel.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

David Taylor

Membro da: 26/09/2012

10 Reputazione

1 Guida realizzata

Team

Cal Poly, Team 16-56, Forte Fall 2012 Membro di Cal Poly, Team 16-56, Forte Fall 2012

CPSU-FORTE-F12S16G56

5 Membri

7 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 493