Parti

Nessuna parte richiesta.

Place the monitor face down.
  • Place the monitor face down.

  • Remove the four 11.5mm screws with a #2 Phillips screwdriver.

  • Remove the stand by pulling it out.

Aggiungi Commento

Remove two 11.5mm screws with a  #2 Phillips screwdriver.
  • Remove two 11.5mm screws with a #2 Phillips screwdriver.

  • Remove the plastic bar.

Aggiungi Commento

  • Using a #2 Phillips screwdriver, remove the six 7mm screws at the circled locations.

Aggiungi Commento

  • Pry the monitor using the plastic opening tool to release the clips holding the cover on.

    • There are four clips on each side, four on the top, and one on the bottom.

    • You may hear a loud snapping noise when releasing the clips. Do not be alarmed, it is natural.

  • Once all the clips have been released, remove the cover by pulling it up.

Aggiungi Commento

  • Using the #2 Phillips screwdriver, remove the one 6mm screw.

  • Unplug the indicated cable by pulling on the base.

  • Slide the cover toward the top of the monitor.

  • Remove the cover.

Aggiungi Commento

  • Disconnect the two connectors to the speakers by gently pulling on the hard plastic straight up.

Aggiungi Commento

  • Carefully peel the tape from the board.

Aggiungi Commento

  • Flip the monitor so the screen is facing you.

  • Using Phillips #2 screwdriver remove the four 6.25 mm screws securing the speakers:

Aggiungi Commento

  • Carefully lift the speakers up.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Team

Cal Poly, Team 16-56, Forte Fall 2012 Membro di Cal Poly, Team 16-56, Forte Fall 2012

CPSU-FORTE-F12S16G56

5 Membri

7 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 315