Salta al contenuto principale

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Sanyo VPC S1275 Case Replacement

Cosa ti serve

  1. Sanyo VPC S1275 Case Replacement, Battery: passo 1, immagine 1 di 1
    • Place your thumb on the right side of the camera over the battery door.

    • Slide the battery door to the right until the door lifts up.

  2. Sanyo VPC S1275 Case Replacement: passo 2, immagine 1 di 1
    • Remove and recycle old batteries.

  3. Sanyo VPC S1275 Case Replacement, Case: passo 3, immagine 1 di 3 Sanyo VPC S1275 Case Replacement, Case: passo 3, immagine 2 di 3 Sanyo VPC S1275 Case Replacement, Case: passo 3, immagine 3 di 3
    • Unscrew 6 Phillips screws using the #00 Phillips screwdriver.

    • Two screws are on the left side of the camera.

    • Two screws are on the right side of the camera.

    • Two screws are on the bottom of the camera.

  4. Sanyo VPC S1275 Case Replacement: passo 4, immagine 1 di 2 Sanyo VPC S1275 Case Replacement: passo 4, immagine 2 di 2
    • Open battery slot on the bottom of the camera by sliding the door to the right.

    • Remove the 4 mm phillips screw on the bottom right using the #00 phillips screwdriver.

  5. Sanyo VPC S1275 Case Replacement: passo 5, immagine 1 di 3 Sanyo VPC S1275 Case Replacement: passo 5, immagine 2 di 3 Sanyo VPC S1275 Case Replacement: passo 5, immagine 3 di 3
    • Insert spudger in the seam at the bottom of the camera.

    • Gently separate the rear case from the front of the camera.

  6. Sanyo VPC S1275 Case Replacement: passo 6, immagine 1 di 1
    • This step is only needed for the case and logic board replacement

    • Using the #00 phillips screwdriver remove the screw attached to the front casing in the top left corner. Front case should easily separate.

  7. Sanyo VPC S1275 Case Replacement: passo 7, immagine 1 di 1
    • This step is only needed for the case replacement.

    • Using the #00 phillips screwdriver remove the screw on the inside of the battery door.

    • Slide the battery door off of the hinge.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Team

Cal Poly, Team 24-24, Regan Spring 2010 Membro di Cal Poly, Team 24-24, Regan Spring 2010

CPSU-REGAN-S10S24G24

4 Membri

12 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 2

Tutti i Tempi: 1,961