Introduzione

Use this guide to remove or replace the case.

Parti

Nessuna parte richiesta.

Place your thumb on the right side of the camera over the battery door.
  • Place your thumb on the right side of the camera over the battery door.

  • Slide the battery door to the right until the door lifts up.

Aggiungi Commento

Remove and recycle old batteries.
  • Remove and recycle old batteries.

Aggiungi Commento

  • Unscrew 6 Phillips screws using the #00 Phillips screwdriver.

    • Two screws are on the left side of the camera.

    • Two screws are on the right side of the camera.

    • Two screws are on the bottom of the camera.

Aggiungi Commento

  • Open battery slot on the bottom of the camera by sliding the door to the right.

  • Remove the 4 mm phillips screw on the bottom right using the #00 phillips screwdriver.

Aggiungi Commento

  • Insert spudger in the seam at the bottom of the camera.

    • Gently separate the rear case from the front of the camera.

Aggiungi Commento

  • This step is only needed for the case and logic board replacement

  • Using the #00 phillips screwdriver remove the screw attached to the front casing in the top left corner. Front case should easily separate.

Skip this step for the function set replacement.

Ariana Martinez - Replica

  • This step is only needed for the case replacement.

  • Using the #00 phillips screwdriver remove the screw on the inside of the battery door.

  • Slide the battery door off of the hinge.

This step is needed only for the case replacement.

Ariana Martinez - Replica

Conclusione

To reassemble your device, follow these instructions in reverse order.

Ariana Martinez

Membro da: 15/04/2010

50 Reputazione

4 Guide realizzate

Team

Cal Poly, Team 24-24, Regan Spring 2010 Membro di Cal Poly, Team 24-24, Regan Spring 2010

CPSU-REGAN-S10S24G24

4 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 1,759