Introduzione

This guide outlines a procedure for completely removing and replacing a non-functioning motherboard on the Samsung SmartThings Hub.

Parti

Nessuna parte richiesta.

  1. To open your device, gently slide the grey bottom cover in the direction of the arrow as shown.
    • To open your device, gently slide the grey bottom cover in the direction of the arrow as shown.

    Aggiungi Commento

  2. Make sure the batteries are removed before attempting disassembly.
    • Make sure the batteries are removed before attempting disassembly.

    • Using your Phillips #1 screwdriver, remove the four visible 12.5mm screws.

    • Next, either peel up the longer of the two stickers or punch a hole with the tip of your screwdriver to access the fifth 12.5mm screw.

    Aggiungi Commento

    • Once all five screws are removed, split the casing apart by applying gentle upwards pressure against the positive terminals in the battery compartment.

    Aggiungi Commento

    • To remove the motherboard, grip the USB port and the Ethernet port. Lift up, then slide towards the front of the device to release the motherboard from the black retaining clip shown on the right.

    Aggiungi Commento

    • Replace with new, known-good motherboard.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 16

Tutti i Tempi: 184