Introduzione

The replacement of this flash light bulb will be needed when flash mode isn't working.

  1. Unscrew all visible screws indicated by red circles with a #00 Phillips driver.
    • Unscrew all visible screws indicated by red circles with a #00 Phillips driver.

    • Slide memory card cover and unscrew hidden screw underneath with a #00 Phillips driver.

    Aggiungi Commento

  2. Remove the flat side panel by applying gentle pressure toward the bottom of the camera.
    • Remove the flat side panel by applying gentle pressure toward the bottom of the camera.

    • Remove the corner panel by applying pressure away from the shutter button.

    • The memory card cover will come off with the corner panel.

    • Remove the top panel by applying gentle pressure away from the shutter button.

    Aggiungi Commento

    • Remove screws beneath the top panel indicated by red circles with a #00 Phillips driver.

    Aggiungi Commento

    • Remove the front and back covers by pulling them straight apart.

    Aggiungi Commento

    • Remove the screw securing the shutter button to the camera frame.

    • Lift the shutter button to remove it.

    Aggiungi Commento

    • Remove the screws from the circuitry with a Phillips #000 driver.

    • Remove the screw connecting the flash housing to the camera frame with the same driver.

    Aggiungi Commento

    • Pull the flash housing away from the camera frame.

    • Cut the wires connecting the flash module to the circuitry.

    • Connect the new flash module to the circuitry with a soldering iron and electrical solder.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Jade Withrow

Membro da: 08/02/2018

255 Reputazione

2 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 41