Parti

Nessuna parte richiesta.

Turn Samsung SCH3500 around so that the back is facing you. Depress locking tab on the back of the phone with a finger or thumb.
  • Turn Samsung SCH3500 around so that the back is facing you. Depress locking tab on the back of the phone with a finger or thumb.

Aggiungi Commento

Slide battery toward bottom of the phone, ~1/4 inch, to clear the hooks that keep it secured to the back of the phone.
  • Slide battery toward bottom of the phone, ~1/4 inch, to clear the hooks that keep it secured to the back of the phone.

Aggiungi Commento

  • Lift battery away from phone case.

  • The battery is now removed from the device. Congratulations.

Aggiungi Commento

  • Grasp antenna firmly and rotate counterclockwise to unscrew it from the phone.

Aggiungi Commento

  • When unscrewed, pull the antenna straight up and out.

Aggiungi Commento

  • Pull guide tube free from its retaining ring and slide it out the top, like the antenna (optional).

  • The antenna and its guide tube are now removed from the phone. Congratulations.

Aggiungi Commento

  • Remove the four screws using a T6 Torx screwdriver.

Aggiungi Commento

  • Work from the bottom of the phone, separating the two halves of the case.

  • Note: Take care to keep the logic board with the front case half. Part of the logic board is exposed to the sticker under the battery on the rear case half.

Aggiungi Commento

  • Angle the rear case half away from the top of the front case half, pivoting the hooks out of their clasps.

  • Caution: Do not fully separate the halves. There is an antenna ribbon connected to the logic board from the back cover.

Aggiungi Commento

  • Disconnect the antenna ribbon cable from the logic board at the Zero Insertion Force (ZIF) connector. The brown portion of the connector lifts up to release the cable end.

  • The Back Cover is now removed. Congratulations.

Aggiungi Commento

  • Remove the connector for the earpiece speaker, located on the upper end of the logic board.

Aggiungi Commento

  • Turn the front cover over, gently prying the logic board away from the front cover. It will remain attached by two wires from the front of the board.

Aggiungi Commento

  • Work the microphone out of its socket on the front cover; it will remain attached to the logic board, its wires are soldered.

  • The logic board is now removed from the phone. Congratulations.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Brett Tomashitis

Membro da: 09/03/2012

36 Reputazione

10 Guide realizzate

Team

Clemson, Team 2-6, Benson Spring 2012 Membro di Clemson, Team 2-6, Benson Spring 2012

CLEM-BENSON-S12S2G6

2 Membri

10 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 2

Tutti i Tempi: 703