Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
Attrezzo utilizzato in questo passaggio:Tweezers$4.99-
Flip the device so that the bottom of the device is facing you. Remove these feet with a pair of tweezers.
-
Remove the four 10mm long screws with the Phillips #1 screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the connector from the board by pressing down on the center tab while nudging the connector away with a spudger.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two 10mm long screws from the board utilizing the Phillips #1 screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a spudger to press the plastic tab away from the board until the board pops up.
-
Remove the board with the USB module from the device.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two 12mm long screws with the Phillips #1 screwdriver.
-
Unplug white plug connected to the green circuit board.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the four 12mm long screws with the Phillips #1 screwdriver.
-
Remove the cover, and slide the cord through the hole.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
Attrezzo utilizzato in questo passaggio:Tweezers$4.99-
Remove rubber covers covering the screws with pair of tweezers.
-
Remove the six 12mm screws that are under the rubber covers with the Phillips #1 screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the unscrewed cover as much as possible.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Push the body out through the outer shell of device.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the eight 12mm long screws around the body with the Phillips #1 screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pry the two halves of the body open using a metal spudger.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the plugs located topmost right and closest to the bottom in picture.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the four 12mm long screws with the Phillips #1 screwdriver .
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unscrew the four 8mm screws on the side of the motherboard with the Phillips #1 screwdriver .
-
Remove the Wireless Module from the device.
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.