Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Turn the camera upside down. Only remove the lens if you have to in order to access the battery compartment, as dust particles could easily enter the main body and fall onto the delicate sensor.
-
Slide the button to the left to open the battery compartment.
-
Push the blue button up to release the battery.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the four 7.3 mm Phillips screws from the front of the lens assembly.
-
Remove the silver ring with tweezers.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use tweezers to remove the black plastic ring and small metal ring inside the lens assembly.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use tweezers to lift the pyramid screw and spring from the lens assembly.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the three 4.3 mm Phillips screws from the bottom of the camera.
-
Remove the 4.3 mm Phillips screw hiding inside the battery compartment.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the 4.2 mm Phillips screw from the left handgrip.
-
Remove the two 4.2 mm Phillips screws from the right handgrip.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use tweezers to remove the metal shield from the external flash mount.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the four 5 mm Phillips screws from the external flash mount .
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Slowly pull the bottom of the back case away from the camera.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the flat end of a spudger to pry the flat topped connector straight up from the motherboard.
-
Remove the back case.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
To remove the metal shield on the back case, remove the following screws:
-
Five black 4.2 mm Phillips screws .
-
Four silver 5.3 mm Phillips screws.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Insert the pointed end of a spudger into the whole on the ribbon cable holding the button panel to the back case.
-
Remove the button panel.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a spudger to peel back the LCD ribbon from the back case.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use tweezers to remove the plastic cover on the LCD hinge.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Tilt the LCD so it lays flat against the back case.
-
Wiggle the LCD joints and pull the LCD away from the back case.
-
Annulla: non ho completato questa guida.
Altre 2 persone hanno completato questa guida.