Salta al contenuto principale

Introduzione

The replacement of your screen takes a little work. With the right equipment though it is not too difficult to do. Just be ready to unscrew a lot of screws.

  1. Samsung NX30 Screen Replacement, Battery: passo 1, immagine 1 di 1
    • Flip the camera over so that the bottom of the camera is up.

    • Push the battery switch towards the back of the camera.

  2. Samsung NX30 Screen Replacement: passo 2, immagine 1 di 2 Samsung NX30 Screen Replacement: passo 2, immagine 2 di 2
    • Locate the blue switch above the battery pack.

    • Slide the blue switch into the camera in the direction of the arrow on the switch. When the switch has been pushed in the battery will spring up.

  3. Samsung NX30 Screen Replacement: passo 3, immagine 1 di 1
    • Pull the battery out.

  4. Samsung NX30 Screen Replacement, Screen: passo 4, immagine 1 di 3 Samsung NX30 Screen Replacement, Screen: passo 4, immagine 2 di 3 Samsung NX30 Screen Replacement, Screen: passo 4, immagine 3 di 3
    • Unscrew the nine 4mm Phillips head screws surrounding the body of the camera. They are located on the bottom of the camera and both sides of the camera.

  5. Samsung NX30 Screen Replacement: passo 5, immagine 1 di 3 Samsung NX30 Screen Replacement: passo 5, immagine 2 di 3 Samsung NX30 Screen Replacement: passo 5, immagine 3 di 3
    • Pull the viewer out from the camera and then up.

    • Unscrew the two black 4mm Phillips head screws under it.

  6. Samsung NX30 Screen Replacement: passo 6, immagine 1 di 2 Samsung NX30 Screen Replacement: passo 6, immagine 2 di 2
    • Once the screws are all removed, place the camera face down, with the screen facing up.

    • Pry open the body using the plastic opening tool.

    • Gently open the body.

  7. Samsung NX30 Screen Replacement: passo 7, immagine 1 di 2 Samsung NX30 Screen Replacement: passo 7, immagine 2 di 2
    • Then use the plastic opening tool to dislodge the Ribbon Cable, located near the top of the camera, from the Circuit Board.

    • The Ribbon Cable will be disconnected from the Circuit Board when you are done.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Julia Kilcup

Membro da: 03/02/2016

384 Reputazione

3 Guide realizzate

Team

UW Tacoma, Team 1-4, Rose Winter 2016 Membro di UW Tacoma, Team 1-4, Rose Winter 2016

UWT-ROSE-W16S1G4

4 Membri

10 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 4

Ultimi 30 Giorni: 37

Tutti i Tempi: 1,439