Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Turn off the computer.
-
Disconnect the charging cable from the laptop.
-
Flip the laptop upside down with the front face down on a flat surface.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Slide the left and right switch to the "unlocked" position.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
While holding the left and right hand switches in the "unlocked" position, push the battery away from the computer.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the Phillip's 00 screwdriver, unscrew the fourteen 7mm screws until the back panel comes loose.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using either the blue plastic opening tools or spudger tool, wedge one in between the back panel and the laptop.
-
Apply pressure upwards till the back panel pops off.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
The computer should be open with the motherboard exposed and internal components exposed. You should now be able to access the Fan and RAM. There are more necessary steps to follow before accessing the screen and keyboard.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unclip the two white wires connected to the computer chip on the motherboard by pulling the white wire toward you.
-
Remove the yellow tape securing the black cable that is connected to the motherboard.
-
Once you have removed the yellow tape, unplug the black cable from its connection on the motherboard.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a Phillips #00 screwdriver to unscrew the four 5 mm screws located on the two hinges.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Slowly remove the screen case from the rest of the laptop by pulling the screen case out of the hinge sockets.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a Phillips #00 to unscrew the four 5mm screws located at the top and bottom corners of the screen bezel.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the spudger or plastic opening tools to wedge it in-between the screen bezel and bottom of the screen case.
-
Apply pressure upwards to pop the screen bezel open.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a Phillips #00 screwdriver to unscrew the four 5mm mounting screws that secure the screen to the bottom case.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift the screen out of the bottom screen case and locate the white plug connected to the bottom case.
-
Pull the wires away from you to unplug the wires from their connection on the bottom screen case.
-
Unclip half of the black case hinge to release the wire from its casing
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
The screen is fully disconnected from the screen bezel and can now be removed.
-
Annulla: non ho completato questa guida.
Altre 6 persone hanno completato questa guida.