Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Rotate the camcorder so that back is facing you. Then flip open the LCD screen.
-
Locate and remove the 4.5mm Phillips #00 screws in the LCD screen base.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Close the LCD screen. Then lift the silver base away from the camcorder.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Rotate the camcorder so that it is facing you.
-
Locate and remove the two 4.5mm Phillips #00 screws.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Open the LCD screen and rotate it around 90 degrees.
-
Locate the small prying notch and use a prying tool to slowly remove the LCD cover.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate and remove the two 3.5mm Phillips #00 screws holding the back cover.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
Attrezzo utilizzato in questo passaggio:Tweezers$4.99-
With tweezers gently unclip the silver tab holding the ribbon wire.
-
Gradually feed the ribbon wire through the hole to remove the screen.
-