Aggiusta la tua roba Comunità Store

Samsung Galaxy Tab A 9.7 Display Digitizer Replacement

Introduzione

If the glass on the screen of your Samsung Galaxy Tab A 9.7 is cracked or damaged in any way, your device could be nearly unusable. This guide will help you replace the display glass in an easy and safe way.

Cosa ti serve

  1. Samsung Galaxy Tab A 9.7 Display Digitizer Replacement, Display Glass: passo 1, immagine 1 di 1

    • Microwave the iOpener for 30 seconds.

    • Place the iOpener on each side of the screen for 30 seconds.

    Modifica

  3. Samsung Galaxy Tab A 9.7 Display Digitizer Replacement: passo 2, immagine 1 di 1

    • Take a metal spudger and wedge it between the screen and the glass.

    • Avoiding the screen itself, run the spudger along the perimeter of the device to weaken the glue between the glass and screen, and pry the glass off.

    Modifica

  4. Samsung Galaxy Tab A 9.7 Display Digitizer Replacement: passo 3, immagine 1 di 1

    • Using a suction cup, gently remove the screen from the device.

    • When placing a new screen on the device, remember that you will have to reapply adhesive to the outside of the screen.

    Modifica
Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

Autore

con 5 altri collaboratori

Paulina Nguyen

Membro da: 04/26/17

982 Reputazione

6 Guide realizzate

Distintivi: 13

+10 altri distintivi

Team

Cal Poly, Team S1-G3, Livingston Spring 2017 Membro di Cal Poly, Team S1-G3, Livingston Spring 2017

CPSU-LIVINGSTON-S17S1G3

1 Membro

12 Guide realizzate

4 Commenti

This is not entirely correct. For the proper way to replaced this glass, you need to remove the back cover as well, in order to connect the digitizer flex cable to the board.

Hank - Replica

incomplete.

Niah Mason - Replica

Not a good tutorial.

Easy Repair - Replica

The following steps are completely missing:

- remove the backcover with a pick or Spudger running between back cover and body.

- flip up the lock for the flex cable with a spudger

- slide the flex cable through the body and remove the display

- slide the flex cable of a new display throught the body to the backside

- connect the flex cable to the connector (be aware of correct aligning) and flip down the lock

- glue the display back to the body (do not use much pressure as it may crack the new display!)

- clip back on the back cover

BenZ78 - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 8

Tutti i Tempi: 3,676