Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Insert an opening pick between the rear case and the plastic rim.
-
Slide the pick along the edge of the rear case until you release the plastic clips attaching the rear case to the display.
-
Continue to slide the pick around the edge of the rear case until all clips are released.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the flat end of a nlyon spudger to pry up the black plastic tabs securing the two ZIF connectors.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the flat end of a nylon spudger to pry up the brown plastic tab securing the orange ribbon cable.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove all three ribbon cables by gently pulling the cables away from the ZIF connectors.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a Phillips #000 screwdriver to remove the ten 3mm screws securing the battery to the chassis.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the pointed end of a nylon spudger to pry the two battery connections away from the motherboard.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift with a nylon spudger to remove the battery.
-
Annulla: non ho completato questa guida.
Altre 75 persone hanno completato questa guida.
7 Commenti
Great, Thanks for the help. It was very useful.
why are there white lines all over the screen after a new battery was installed
brilliant ! worked extremely well !
Thank you very much for the information. I have one question, though. The new battery works, but it takes a VERY long time to charge. More than a day, in fact. Any idea what could be causing that? Is it possible that one of the connections is not tight enough? If so, which connection might that be?
Thank you.
Very easy instructions. Thank you. My only snag was that the ten screws holding the battery were extremely reluctant to undo. wrecked the IFxit screw driver. Fortunately, I had another one. My tip for anyone doing this little job, is to use quit a lot of downward pressure on the screws. Turn them 1/4 turn anticlockwise and back again. Do this several times until they turn freely. You will then have an easy job. I will replace those screws with a tiny blob of 'Never Seize'.
