Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Insert your fingernail or a plastic opening tool into the pivot on the side of the SIM tray.
-
Pry open the tray to get it out of the socket.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the SIM tray with SIM card from the phone.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Heat the front face (sides, top, bottom) of the phone with the iOpener, a hair dryer, or a heat gun for 60 seconds to loosen the adhesive around the edge of the glass.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Attach a suction cup to the lower half of the screen.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the suction cup, pull gently the lower half of the panel.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Once you’ve opened a large enough gap, insert a plastic tool at the bottom, between the glass and the rest of frame of the phone.
-
Slide the plastic opening tool around the screen, prying the display gently away from the body
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pull the lower half of the screen screen with the suction cup while holding down the frame of the phone to separate both components.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Once the glass is off, you will see a small clip covering the screen connection to the motherboard at the top of the phone. Use tweezers to grab the clip by the crease on its side and pull it out.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Undo the screen connection with a plastic tool.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the display assembly (LCD and Digitizer).
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the Phillips Head Screwdriver sized PH000 to remove the sixteen 4mm screws from the frame.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Put a little pressure on the top, on the bottom, and on the sides of the phone to separate the rear case.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Once all the clips have popped, pull out the rear case to separate it from the frame with the battery.
-
The battery will be on the back side of this frame.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Insert a plastic opening tool on the side of the frame and pull out the battery.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a plastic opening tool to undo the connector and the two wires on the motherboard.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the Phillips #000 screwdriver to remove the two 4mm screws from the USB board.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Insert a plastic opening tool under the USB board and remove the USB board from the rear case.
-