Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
NOTE: It is suggested to remove the battery, S Pen, SD Card, and SIM card (if your phone uses a SIM card).
-
Begin by heating the edges of the screen. The adhesive on the Galaxy Note 4 is weaker than on newer generations and will release easier, requiring less heat and prying.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Slowly work your way around the edges of the screen with a pry tool or pick.
-
Work your way around the top and sides of the device, and very carefully approach the adhesive on the bottom of the phone. The Galaxy Note 4's touch-sensitive pads lay in the way of your opening picks and it is very easy to sever them.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Insert the Jimmy underneath the LCD to cut the adhesive in the middle part. The adhesive is strong so make sure you are underneath the copper insulation before separating.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Notice 1: The adhesive is in the red line.
-
Notice 2: If you insert the spudger from right side, keep the length of the tool in less than 2.2cm, which is for avoiding damaging the home button flex.
-
Notice 3: If you insert the spudger from left side, keep the length of the tool in less than 4.4cm for the same reason.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Notice 4: Pay attention to the part with LCD screen flex. When you cut the adhesive, leave the top part alone to avoid damage the flex. But if it's the broken screen, you don't need to worry so much.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Release S Pen touch sensor film connector and LCD screen connector.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Separate the LCD screen from the frame of the device.
-
Annulla: non ho completato questa guida.
Altre 159 persone hanno completato questa guida.
42 Commenti
Here in our tech community we have been discussing the foil under the LCD. We are doing more testing but there might be a connection with the foil functioning in conjunction with S-Pen and AirView. Can anyone confirm this?
Yes, the foil permits the s pen to function. If you have the part of the foil that was riped off you can tape it back.
the foil itself has nothing to do with the functioning of the spen. It is for heat dissipation