Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
This is the back of the device and where you will begin to take it apart
-
It is neccesary to remove this piece first before removing the bigger back piece.
-
Use the plastic opening tools to pry along the indicated box.
-
Lift up the silver piece to reveal the rest of the back cover.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unscrew the three 5 mm screws indicated by the red circles with the Philips #00 screwdriver.
-
Using the plastic opening tools pry along the bottom of the device, moving to the sides of the cover to the top.
-
Remove the back cover.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Carefully remove all of the ribbons that connect over the battery.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove all of the 3 mm screws indicated by a red circle with the #00 Philips Screwdriver.
-
Disconnect the battery connector from the motherboard.
-
Now you may remove the battery. The replacement battery should be 3.7 Volts and 25.9 kWh.
-
Annulla: non ho completato questa guida.
Altre 49 persone hanno completato questa guida.
Team
USF Tampa, Team 3-7, Brown Fall 2014 Membro di USF Tampa, Team 3-7, Brown Fall 2014
USFT-BROWN-F14S3G7
3 Membri
9 Guide realizzate
13 Commenti
In Step 3, mention that you need to lift up on the black locks to take out the ribbons.
Actually, on my device one lock was colored faun (beige). Lift them seen from the edge of the Note, not on the cable side.
dada64 -
Also, mention that you can disconnect the battery from the device by gently pulling out the battery and gently lifting up the wires.
This is not a plug to be pulled in the direction of the cables but vertically off the board. Putting it back in you simply plug the contacts down first, then the cable side of the plug.
dada64 -
When replacing the back cover, hook the bottom edge into the frame along the edge before trying to snap the rest in place along the sides.
