Salta al contenuto principale
  1. This is the back of the device and where you will begin to take it apart It is neccesary to remove this piece first before removing the bigger back piece. Use the plastic opening tools to pry along the indicated box.
    • This is the back of the device and where you will begin to take it apart

    • It is neccesary to remove this piece first before removing the bigger back piece.

    • Use the plastic opening tools to pry along the indicated box.

    • Lift up the silver piece to reveal the rest of the back cover.

  2. Unscrew the three 5 mm screws indicated by the red circles with the Philips #00 screwdriver. Using the plastic opening tools pry along the bottom of the device, moving to the sides of the cover to the top. Remove the back cover.
    • Unscrew the three 5 mm screws indicated by the red circles with the Philips #00 screwdriver.

    • Using the plastic opening tools pry along the bottom of the device, moving to the sides of the cover to the top.

    • Remove the back cover.

    • At this point use anti-static gloves or do NOT take it apart on carpet.

  3. Kit riparazione batterie MacBook

    A partire da $69.99

    Buy Now

    Kit riparazione batterie MacBook

    A partire da $69.99

    Buy Now
  4. Carefully remove all of the ribbons that connect over the battery from the locations indicated by the yellow circles. Carefully remove all of the ribbons that connect over the battery from the locations indicated by the yellow circles. Carefully remove all of the ribbons that connect over the battery from the locations indicated by the yellow circles.
    • Carefully remove all of the ribbons that connect over the battery from the locations indicated by the yellow circles.

  5. Remove all of the 3 mm screws indicated by a red circle with the #00 Philips Screwdriver. Disconnect the battery from the location indicated by a yellow circle Now you may remove the battery. The replacement battery should be 3.7 Volts and 25.9 kWh.
    • Remove all of the 3 mm screws indicated by a red circle with the #00 Philips Screwdriver.

    • Disconnect the battery from the location indicated by a yellow circle

    • Now you may remove the battery. The replacement battery should be 3.7 Volts and 25.9 kWh.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 42 persone hanno completato questa guida.

Tyler Salomone

Membro da: 22/09/2014

927 Reputazione

3 Guide realizzate

Team

USF Tampa, Team 3-7, Brown Fall 2014 Membro di USF Tampa, Team 3-7, Brown Fall 2014

USFT-BROWN-F14S3G7

3 Membri

9 Guide realizzate

In Step 3, mention that you need to lift up on the black locks to take out the ribbons.

John Peterson - Replica

Actually, on my device one lock was colored faun (beige). Lift them seen from the edge of the Note, not on the cable side.

dada64 -

Also, mention that you can disconnect the battery from the device by gently pulling out the battery and gently lifting up the wires.

John Peterson - Replica

This is not a plug to be pulled in the direction of the cables but vertically off the board. Putting it back in you simply plug the contacts down first, then the cable side of the plug.

dada64 -

When replacing the back cover, hook the bottom edge into the frame along the edge before trying to snap the rest in place along the sides.

charliesmallman55 - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 26

Ultimi 7 Giorni: 105

Ultimi 30 Giorni: 475

Tutti i Tempi: 71,379