Salta al contenuto principale

Introduzione

Use this guide to replace the back cover of your Galaxy A3 (2016).

  1. Start by switching off your phone. Take an iOpener to heat up and soften the glue behind the back cover. Lift the bottom part of your back cover with a suction handle and insert an opening pick.
    • Start by switching off your phone.

    • Take an iOpener to heat up and soften the glue behind the back cover.

    • Lift the bottom part of your back cover with a suction handle and insert an opening pick.

  2. Slide the opening pick up to the rear camera to separate the back cover from the frame. Slide the opening pick up to the rear camera to separate the back cover from the frame. Slide the opening pick up to the rear camera to separate the back cover from the frame.
    • Slide the opening pick up to the rear camera to separate the back cover from the frame.

  3. Insert a second opening pick and move around the other corner at the bottom part of the back cover. Insert a second opening pick and move around the other corner at the bottom part of the back cover.
    • Insert a second opening pick and move around the other corner at the bottom part of the back cover.

  4. Move the second pick along the left side of the back cover to loosen the adhesive. Move around the upper left corner and loosen the adhesive above the rear camera. After loosening all the edges and sides of the back cover use an iOpener to loosen the adhesive underneath the center of it.
    • Move the second pick along the left side of the back cover to loosen the adhesive.

    • Move around the upper left corner and loosen the adhesive above the rear camera.

    • After loosening all the edges and sides of the back cover use an iOpener to loosen the adhesive underneath the center of it.

  5. Insert a plastic card at the bottom and slide it underneath the back cover. Separate the glue until you reach the rear camera. Now you can slowly lift up the back cover and finally remove it.
    • Insert a plastic card at the bottom and slide it underneath the back cover.

    • Separate the glue until you reach the rear camera.

    • Now you can slowly lift up the back cover and finally remove it.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 15 persone hanno completato questa guida.

Dominik Schnabelrauch

Membro da: 23/11/2016

90.529 Reputazione

375 Guide realizzate

Team

iFixit Membro di iFixit

Community

137 Membri

16.007 Guide realizzate

where can I buy the back cover? tnx

rompecolleoni - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 7

Ultimi 7 Giorni: 45

Ultimi 30 Giorni: 138

Tutti i Tempi: 12,750