Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Press button on back of phone below camera.
-
While button is depressed, remove the back panel of the phone by it sliding off (not shown in picture).
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Grasp the bottom corners of the battery with two fingers and gently lift.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using an iPod opening tool, remove the screw cover in the top left corner by lifting it up.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the Phillips #00 screwdriver to remove the six screws on the back of the phone. Three are evenly spaced on each side.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Slide the iPod opening tool into the seam on the side of the phone and turn it slightly to unhook the eight clips.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Once all eight of the clips have been unhooked, lift the back panel off of the phone.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using an iPod opening tool, unlatch the ribbon cable located in the lower right corner of the motherboard.
-
Carefully remove the ribbon.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Grasp the rubber keyboard in the corner with your fingers and lift to remove.
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.