Aggiusta la tua roba Comunità Store

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Samsung Captivate Camera Assembly Replacement

Introduzione

The camera assembly is susceptible to various environmental forces such as moisture, vibration, and shock. Replacing this part is easy.

Cosa ti serve

  1. Samsung Captivate Camera Assembly Replacement, Battery: passo 1, immagine 1 di 1

    • Remove the back cover by pressing on the bottom section of the phone and sliding the bottom piece downward.

    • Lift up the back cover.

    Traduci

  2. Samsung Captivate Camera Assembly Replacement: passo 2, immagine 1 di 1

    • Place your finger on the bottom of the battery and lift to remove.

    Traduci

  3. Samsung Captivate Camera Assembly Replacement: passo 3, immagine 1 di 1

    • Replace the old battery with the new one.

    Traduci

  5. Samsung Captivate Camera Assembly Replacement, Rear Case: passo 4, immagine 1 di 1

    • Insert the spudger underneath the bottom section of the phone.

    • Gently lift and push the spudger to slide the bottom section down to reveal two hidden screws.

    Traduci

  6. Samsung Captivate Camera Assembly Replacement: passo 5, immagine 1 di 1

    • Remove the six 4.5mm #000 Phillips screws.

    Traduci

  7. Samsung Captivate Camera Assembly Replacement: passo 6, immagine 1 di 3 Samsung Captivate Camera Assembly Replacement: passo 6, immagine 2 di 3 Samsung Captivate Camera Assembly Replacement: passo 6, immagine 3 di 3

    • Starting at a bottom corner, use the spudger to separate the rear case from the front display.

    • Move the spudger towards the top on both sides. The plastic opening tool is easier to use for this step.

    • Be careful when detaching the top. Free each side, stopping short of the center of the cover. Apply backward pressure on both corners with a finger applying pressure on the center, and slide the whole back cover toward the bottom of the device. Note: forcing the cover can result in cracked plastic.

    Traduci

  8. Samsung Captivate Camera Assembly Replacement: passo 7, immagine 1 di 1

    • Separate the rear case from the phone.

    Traduci

  9. Samsung Captivate Camera Assembly Replacement, Camera Assembly: passo 8, immagine 1 di 1

    • Use the spudger tool to pry up the chip labeled "NEC." This releases the chip.

    Traduci

  10. Samsung Captivate Camera Assembly Replacement: passo 9, immagine 1 di 1

    • Gently lift the camera assembly out of the plastic housing.

    Traduci
Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 3 persone hanno completato questa guida.

Autore

con 4 altri collaboratori

Drew Bentz

Membro da: 09/22/11

565 Reputazione

5 Guide realizzate

Distintivi: 11

+8 altri distintivi

Team

Cal Poly, Team 20-25, Maness Fall 2011 Membro di Cal Poly, Team 20-25, Maness Fall 2011

CPSU-MANESS-F11S20G25

3 Membri

9 Guide realizzate

2 Commenti

Is this for the front facing camera

tracy mann - Replica

No, this is for the rear facing camera. The Samsung Captivate does not have a front facing camera.

Will Budney -

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 11

Tutti i Tempi: 2,332