Salta al contenuto principale

Samsung Captivate Antenna Cable Replacement

Cosa ti serve

  1. Samsung Captivate Antenna Cable Replacement, Battery: passo 1, immagine 1 di 1
    • Remove the back cover by pressing on the bottom section of the phone and sliding the bottom piece downward.

    • Lift up the back cover.

  2. Samsung Captivate Antenna Cable Replacement: passo 2, immagine 1 di 1
    • Place your finger on the bottom of the battery and lift to remove.

  3. Samsung Captivate Antenna Cable Replacement: passo 3, immagine 1 di 1
    • Replace the old battery with the new one.

  4. Samsung Captivate Antenna Cable Replacement, Rear Case: passo 4, immagine 1 di 1
    • Insert the spudger underneath the bottom section of the phone.

    • Gently lift and push the spudger to slide the bottom section down to reveal two hidden screws.

  5. Samsung Captivate Antenna Cable Replacement: passo 5, immagine 1 di 1
    • Remove the six 4.5mm #000 Phillips screws.

  6. Samsung Captivate Antenna Cable Replacement: passo 6, immagine 1 di 3 Samsung Captivate Antenna Cable Replacement: passo 6, immagine 2 di 3 Samsung Captivate Antenna Cable Replacement: passo 6, immagine 3 di 3
    • Starting at a bottom corner, use the spudger to separate the rear case from the front display.

    • Move the spudger towards the top on both sides. The plastic opening tool is easier to use for this step.

    • Be careful when detaching the top. Free each side, stopping short of the center of the cover. Apply backward pressure on both corners with a finger applying pressure on the center, and slide the whole back cover toward the bottom of the device. Note: forcing the cover can result in cracked plastic.

  7. Samsung Captivate Antenna Cable Replacement: passo 7, immagine 1 di 1
    • Separate the rear case from the phone.

  8. Samsung Captivate Antenna Cable Replacement, Antenna Cable: passo 8, immagine 1 di 2 Samsung Captivate Antenna Cable Replacement, Antenna Cable: passo 8, immagine 2 di 2
    • Use a spudger tool to pry up the antenna cable from the connector on the motherboard.

    • Pry up the other end of the cable from the connector on the antenna array.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 7 persone hanno completato questa guida.

Drew Bentz

Membro da: 09/22/11

565 Reputazione

5 Guide realizzate

Team

Cal Poly, Team 20-25, Maness Fall 2011 Membro di Cal Poly, Team 20-25, Maness Fall 2011

CPSU-MANESS-F11S20G25

3 Membri

9 Guide realizzate

2 Commenti

Quick question, is this the antenna for wifi or cellular network?

Michael Perdomo - Replica

This is actually just the cable that connects the motherboard to the antenna array. I believe the antenna array that it connects to is for WiFi though.

Drew Bentz -

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 4

Tutti i Tempi: 3,597