Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the Phillips #00 Screwdriver to remove the single 9.6mm screw holding the top cover in place.
-
Remove the cover by sliding it up and then out.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Disconnect the two ribbons that connect the disc drive to the motherboard.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Push in on the two metal tabs on the side of the disc drive.
-
Push forward to slide the disc drive out of the casing.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the Phillips #00 Screwdriver to remove the two 6.4 mm screws holding the cage in place.
-
Lift the cage up to remove it.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Push in the small white lever and pull it towards you to release the cord.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Move the power cord out from under the metal tab on the side of the case.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the rubber spacer on the edge of the case holding the cord in place.
-
Remove the power cord from the device.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
After the power cord has been disconnected, remove the yellow circuit board from the Blu ray player.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the Phillips #00 screwdriver to remove the 9.7mm screw holding the HDMI port in place on the outside of the case.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the Phillips #00 screwdriver to remove the 6.4mm screw holding the motherboard in place.
-
Pull the motherboard up to remove it from the device.
-