Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using a #1 Phillips head screwdriver, remove the three 10mm screws on the back panel.
-
Tilt the back of the top cover forward to remove from chassis.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Gently pull up on the ribbon cable by the blue tab to remove it from the power supply board.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two ribbon cables from the Main Logic Board assembly by gently pulling up on the blue tab.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using a #1 Phillips head screwdriver, remove the two 7.5 mm screws (one not shown) near the front that secures the disc tray to the chassis.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Push two small prongs on either side of disc tray inwards and push disc tray forward.
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.