Salta al contenuto principale

SOMNOcomfort and SOMNObalance Ventilator Filter Replacement

Attrezzature medicali
Né iFixit né questa guida di riparazione sono approvati dal produttore del dispositivo medicale o affiliati ad esso.
  1. SOMNOcomfort and SOMNObalance Ventilator Filter Replacement, Filter: passo 1, immagine 1 di 1
    • Locate the Filter Compartment on the back of the ventilator.

  2. SOMNOcomfort and SOMNObalance Ventilator Filter Replacement: passo 2, immagine 1 di 1
    • Push the compartment cover (22) up (from the bottom)

  3. SOMNOcomfort and SOMNObalance Ventilator Filter Replacement: passo 3, immagine 1 di 1
    • Remove the coarse dust filter(68)

  4. SOMNOcomfort and SOMNObalance Ventilator Filter Replacement: passo 4, immagine 1 di 1
    • Remove the fine dust filter(67)

    • Replace the filters and close the cover on the rear of the unit.

  5. SOMNOcomfort and SOMNObalance Ventilator Filter Replacement: passo 6, immagine 1 di 1
    • Reset the filter change indicator by pressing and holding the on/off switch(19) until the filter change indicator goes blank.

    • If the fine filter was changed due to soiling before 250 operating hours, the hours meter must be reset to zero. Proceed as follows:

    • When switching the unit on, press and hold the on/off switch 19. The filter change indicator will come on after about three seconds before going off again after another three seconds. Release the on and off switch.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Diya Jamwal

Membro da: 11/07/18

553 Reputazione

3 Guide realizzate

Team

Cal Poly, Team S1-G3, Zimmerman Spring 2020 Membro di Cal Poly, Team S1-G3, Zimmerman Spring 2020

CPSU-ZIMMERMAN-S20S1G3

5 Membri

10 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 1

Tutti i Tempi: 116