Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Store

  1. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    Remove the screws on the back of the controller with the Phillips #000 screwdriver. Hold the controller with the bottom plate facing up, gently remove the top plate that is connected to the motherboard of the controller. Set the top plate aside. Be sure to separate the two plates with the bottom facing up, to keep the buttons from falling out.
    • Remove the screws on the back of the controller with the Phillips #000 screwdriver.

    • Hold the controller with the bottom plate facing up, gently remove the top plate that is connected to the motherboard of the controller. Set the top plate aside.

    • Be sure to separate the two plates with the bottom facing up, to keep the buttons from falling out.

    • Place screws on magnetic project mat to avoid losing any screws.

  2. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    CAUTION: Pull gently on the rubber membranes to avoid tearing . Use two fingers to remove each rubber membrane that rests on top of the buttons.
    • CAUTION: Pull gently on the rubber membranes to avoid tearing .

    • Use two fingers to remove each rubber membrane that rests on top of the buttons.

  3. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    Pop the button out from the front side of the controller.
    • Pop the button out from the front side of the controller.

    • Pull the button out from the backside using the other hand.

    • Note: All removable buttons can only be placed in their respective holes due to unique groove patterns on the buttons. Keep in mind where each button belongs to make re-assembly easier.

    • Note: All buttons can be removed except for the D-Pad.

  4. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    Repeat Step 5 for the remaining  buttons.
    • Repeat Step 5 for the remaining buttons.

Linea Traguardo

Un'altra persona ha completato questa guida.

Viet Nguyen

Membro da: 17/04/2018

208 Reputazione

2 Guide realizzate

Team

Cal Poly, Team S24-G12, Maness Spring 2018 Membro di Cal Poly, Team S24-G12, Maness Spring 2018

CPSU-MANESS-S18S24G12

4 Membri

10 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 10

Ultimi 30 Giorni: 38

Tutti i Tempi: 671