Aggiusta la tua roba Comunità Store

Ryobi RJ1861V Saw Bar Assembly Replacement

Introduzione

This guide demonstrates how to remove and replace the saw bar assembly in a Ryobi RJ1861V reciprocating saw.

Cosa ti serve

  1. Ryobi RJ1861V Saw Bar Assembly Replacement, Saw Bar Assembly: passo 1, immagine 1 di 1

    • Use a Torx T5 screwdriver to remove the single 8 mm screw securing the shoe.

    Modifica

  2. Ryobi RJ1861V Saw Bar Assembly Replacement: passo 2, immagine 1 di 2 Ryobi RJ1861V Saw Bar Assembly Replacement: passo 2, immagine 2 di 2

    • Remove the rubber sleeve.

    • You may have to use some force as it has a tight fit.

    Modifica

  3. Ryobi RJ1861V Saw Bar Assembly Replacement: passo 3, immagine 1 di 1

    • Use a Torx T5 screwdriver to remove the six screws on the underside of the device.

    Modifica

  4. Ryobi RJ1861V Saw Bar Assembly Replacement: passo 4, immagine 1 di 1

    • Use a Torx T5 screwdriver to remove the four screws on the top of the gear case.

    • There are two screws on each side of the device.

    Modifica

  5. Ryobi RJ1861V Saw Bar Assembly Replacement: passo 5, immagine 1 di 1

    • Remove the backside panel.

    Modifica

  6. Ryobi RJ1861V Saw Bar Assembly Replacement: passo 6, immagine 1 di 1

    • Unscrew the four T5 Torx screws that hold the assembly bar in place.

    Modifica

  7. Ryobi RJ1861V Saw Bar Assembly Replacement: passo 7, immagine 1 di 1

    • Lift the assembly bar up and out of the chassis.

    Modifica
Conclusione

To reassemble your device, follow these instructions in reverse order.

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 11

Ultimi 30 Giorni: 30

Tutti i Tempi: 869