Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Flip the remote so that the buttons lay face down and then remove the back cover.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the batteries by compressing the spring.
-
This will expose the screw shown in red.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the screw using a Phillips #00 screwdriver.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the face of the remote with the plastic opening tool.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using tweezers, remove the motherboard from the remote.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
The contacts should be present with one set being in the bottom of the remote casing and the other set being on the underside of the motherboard for the remote.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Now you will have to remove the existing contacts by way of clipping the line of at an appropriate length away from the contacts.
-
Now solder on your new connections on the board.
-
For the connections to the casing, you should be able to remove them with a little force. If you feel like you are using too much force, feel free to use a heat gun to eliminate some adhesive on the casing side of the contact.
-
Finally, adhere the new contacts to the casing with a "super glue" like Krazy glue.
-