Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Turn the toaster over and remove the rubber bumper feet.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a Phillips #2 screwdriver to remove four 12 mm screws at the base of the toaster shell.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
With the dial facing you, push the toaster base up and away until the base is just over the lip of the shell. This will disconnect the browning dial from the rest of the toaster.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Reach into the shell and grab the back white part of the lever.
-
Hold the grey lever with both your index finger and middle finger. Next, pull it.
-
Remove the shell.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate the black, diamond shaped spring behind the white lever bracket.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
To remove the spring, use the tweezers to push the bottom edge of the spring out and around the metal bracket that keeps the springs in place.
-
Repeat this for the other side.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pulling the bottom of the spring out, lift the left circle up over the metal bracket that extends out from the bread grabbers.
-
Bring the right circle out, down, and around the bracket the extends out from the shelf that the toast would sits on.
-
Remove the right circle.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
If not, then bend the broken spring to the angles of the correct spring.
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.