Introduzione

This process involves removing the back cover and the front cover of the camera.

Parti

Nessuna parte richiesta.

  1. Unscrew a total of seven screws from the left, right, bottom, and back sides of the camera.
    • Unscrew a total of seven screws from the left, right, bottom, and back sides of the camera.

    Aggiungi Commento

  2. To remove back cover, begin by loosening the back cover from both the left and the right sides of the camera.
    • To remove back cover, begin by loosening the back cover from both the left and the right sides of the camera.

    • Remove back cover. After the back cover is removed, the lid of the battery compartment may fall off because it is not securely attached to anything.

    Aggiungi Commento

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • In order to remove the front cover, the film compartment must be opened.

    • To open the film compartment, place your finger on top of the grey latch on the left side of the camera.

    • Push down on the grey latch. The film compartment door should pop open.

    Aggiungi Commento

    • The following step to remove the film compartment door is optional. However, it may aid in the maneuvering of the camera in future steps.

    • To remove the film compartment door, take a thin object such as a toothpick or a small screwdriver and push down on the metal pin holding the film compartment door in place.

    • After pushing the metal pin down, use your fingers to completely remove the metal pin.

    • After the metal pin has been removed, the film compartment door can be removed.

    Aggiungi Commento

    • Unscrew two screws from within the film compartment. These screws are located at the bottom left and the middle right and require a thin shaft screwdriver.

    Aggiungi Commento

    • To remove the front cover, begin by loosening the front cover from the left and the right sides of the camera.

    • Remove the front cover.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Eric Dazet

Membro da: 10/04/2012

352 Reputazione

5 Guide realizzate

Team

Cal Poly, Team 6-21, Amido Spring 2012 Membro di Cal Poly, Team 6-21, Amido Spring 2012

CPSU-AMIDO-S12S6G21

4 Membri

14 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 3

Tutti i Tempi: 231