Introduzione

This is a step by step guide to removing the keyboard cover of an IBM ThinkPad 560z. The keyboard cover is most commonly removed to facilitate the cleaning or replacement of the keyboard.

  1. Remove the 7 mm Philip screws.
    • Remove the 7 mm Philip screws.

    • Remove the 10 mm Philip screws.

    • Remove the 14 mm Philip screw.

    Aggiungi Commento

  2. Open the flap on the left hand side.
    • Open the flap on the left hand side.

    Aggiungi Commento

    • Insert the iPod opening tools between the right and left sides of the latch.

    • Pry the right side of the latch, and then pry the left side to detach the laptop's cover.

    Aggiungi Commento

    • Open the flap on the right side.

    Aggiungi Commento

    • Insert the iPod opening tools towards the right side of the latch.

    • Gently pry the right side out to release the top cover.

    Aggiungi Commento

    • Lift the keyboard slowly.

    • A cable connects the keyboard to the motherboard. If you are not careful, you will damage the cable.

    Aggiungi Commento

    • Use your fingers or a spudger to detach the connector.

    Aggiungi Commento

    • Carefully lift and remove the keyboard.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Derek Driscoll

Membro da: 15/04/2010

119 Reputazione

8 Guide realizzate

Team

Cal Poly, Team 26-27, Regan Spring 2010 Membro di Cal Poly, Team 26-27, Regan Spring 2010

CPSU-REGAN-S10S26G27

3 Membri

18 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 1,498