Introduzione

How to replace speaker

Turn the phone over so that the screen is facing the work surface
  • Turn the phone over so that the screen is facing the work surface

Aggiungi Commento

Press your thumb against the battery latch. While pressing on latch, slide off battery cover towards the bottom of the phone.
  • Press your thumb against the battery latch. While pressing on latch, slide off battery cover towards the bottom of the phone.

  • You may need to apply considerable force on the latch at the bottom of the phone to complete this successfully.

Aggiungi Commento

  • Remove the battery by pushing downward on the area where prongs connect to bottom inside of the phone while using a thumb, finger, or tool to pull on the top of the battery to lift it out.

Aggiungi Commento

  • Using the T6 Torx screwdriver, remove the bottom two screws on the back of the phone.

Aggiungi Commento

  • Remove speaker phone cover by unsecuring the two latches on the edge close to top of the phone with the plastic opening tool.

Aggiungi Commento

  • Detach the speaker phone cover by pulling up on the bottom of the speaker phone cover.

  • As you detach the speaker phone cover you will notice a sticky glue sealing the rubber gasket from the cover to the speaker mesh. This is normal and will correctly reset the first few times the pieces are separated.

Aggiungi Commento

  • Remove top two screws with T6 Torx screw driver, from the back of phone.

Aggiungi Commento

  • Turn the phone sideways and unlatch the hinge on one side of the phone by pushing inwards and twisting to the side with the plastic opening tool.

Aggiungi Commento

  • You should now be able to easily separate the phone into two pieces.

  • The battery prong may fall out when the separation occurs, just don't loose it!

Aggiungi Commento

  • Set aside the bottom part of the phone.

  • Drop out the rubber keypad from the top, so that it does not get in the way.

Aggiungi Commento

  • Use the plastic separator tool to apply significant pressure in a downward motion on the top of the white speaker unit.

Aggiungi Commento

  • The speaker unit should become loose.

  • You can now push the separating tool beneath the speaker and pop it out.

  • Once the defective unit is removed, pop your new speaker unit back into place.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Sean Tiernan

Membro da: 20/01/2010

5 Reputazione

5 Guide realizzate

Team

Cal Poly, Team 3-16, Maness Winter 2010 Membro di Cal Poly, Team 3-16, Maness Winter 2010

CPSU-MANESS-W10S3G16

4 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 1,081