Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the Phillips #2 screwdriver to remove the four 6 mm screws by unscrewing counterclockwise.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the Phillips 6 mm screw that holds the circuit board to the outer shell of the fan.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the top cover containing the circuit board and the wires by pulling it away from the outer shell of the fan.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the screws from the four corners of the circuit board.
-
Remove the circuit board from the top cover.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two 8 mm screws that attach the buttons to the top cover of the fan.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Wipe down the frame that holds the buttons.
-
Annulla: non ho completato questa guida.
Altre 2 persone hanno completato questa guida.
2 Commenti
Great work but our problem is the micro switch itself, after exposing the circuit board I shorted the backside solder connections to cycle the fan on and off, everything works perfectly…..now I only need to know a part number so I can find a on/off micro switch.
any suggestions?
Thanks for any help you can provide
rickkingsbury@comcast.net
Is there a way to keep the fan in ALWAYS ON position. So I can control it’s ON/OFF using a smart plug?