Salta al contenuto principale

Introduzione

Canon "E-18 error" happens when the lens gets stuck in the extended position. The LCD will display a little E-18 in the lower-left corner and start beeping.

Parti

Nessuna parte specificata.

  1. Place camera lens facing upwards on the table.
    • Place camera lens facing upwards on the table.

    • Press and hold down the power button.

    • Simultaneously press down the shutter button.

  2. Kit riparazione batterie MacBook

    A partire da $69.99

    Buy Now

    Kit riparazione batterie MacBook

    A partire da $69.99

    Buy Now
  3. Replace the batteries in the camera.
    • Replace the batteries in the camera.

    • To open the battery cover slide the black lever on the underside of the camera and pull the cover toward the front.

    • Remove the old batteries from the camera and wait a few moments.

    • Put in a fresh set of batteries.

    • Close battery slide and power camera back on.

  4. Put blow dryer in the "no heat" setting prior to plugging it in.
    • Put blow dryer in the "no heat" setting prior to plugging it in.

    • Plug in and turn the blow dryer on.

    • Blow air in the gaps between the lens.

Conclusione

In conclusion, using this guide to fix the E-18 on the lens of the Canon PowerShot A80,will allow the camera to capture photos once again. To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Tim

Membro da: 06/01/2011

151 Reputazione

1 Guida realizzata

Team

Cal Poly, Team 7-31, Regan Winter 2011 Membro di Cal Poly, Team 7-31, Regan Winter 2011

CPSU-REGAN-W11S7G31

6 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 12

Tutti i Tempi: 3,598