Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.
Cosa ti serve
-
-
To repair a short in the wires, the head band has two screws, just above the headphones cups.
-
-
-
-
After removing the two small screws, try closing the headband to it's shortest position. The outer panel will pop out toward the bottom edge.
-
You can then slide the panel out from under the collar. The collar may slide out of place while working, but can easily be slid back during re-assembly.
-
-
-
After inspecting the wire inside, you may notice cracks in the corners were the wires bend when the headphones are folded. I cut a thin strip of electrical tape to use as reinforcement.
-
After sliding the collar up, you can extend the wire, giving you better access for wrapping or replacing.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulla: non ho completato questa guida.
Altre 5 persone hanno completato questa guida.
