Salta al contenuto principale

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Removing Sony Ericsson W350a Keypad

Cosa ti serve

  1. Removing Sony Ericsson W350a Keypad, Flip Cover: passo 1, immagine 1 di 1
    • Place the plastic opening tool in the bottom corner of the phone in the crevice between the flap to remove the cover.

  2. Removing Sony Ericsson W350a Keypad: passo 2, immagine 1 di 1
    • Remove the cover with a slight twisting motion.

  3. Removing Sony Ericsson W350a Keypad, Battery: passo 3, immagine 1 di 2 Removing Sony Ericsson W350a Keypad, Battery: passo 3, immagine 2 di 2
    • Place the phone face down on a flat smooth surface so that the camera, logos, and speaker face up.

    • Using the provided notch on the bottom of the back cover, insert a plastic opening tool and lift upwards to remove the back cover of the phone.

  4. Removing Sony Ericsson W350a Keypad: passo 4, immagine 1 di 3 Removing Sony Ericsson W350a Keypad: passo 4, immagine 2 di 3 Removing Sony Ericsson W350a Keypad: passo 4, immagine 3 di 3
    • Set the cover to the side upon removal.

    • Insert the plastic opening tool into the crevice between the camera and the battery of the phone. Using a gentle prying motion, lift the end of the battery and remove.

    • After removal, recycle the defective battery appropriately.

  5. Removing Sony Ericsson W350a Keypad, Speaker: passo 5, immagine 1 di 2 Removing Sony Ericsson W350a Keypad, Speaker: passo 5, immagine 2 di 2
    • Flip the phone over and remove the Sony Ericsson sticker that is over the phone's ear speaker.

    • Using a T5 screwdriver, loosen and remove the two screws under the Sony Ericsson sticker by turning them counterclockwise.

  6. Removing Sony Ericsson W350a Keypad: passo 6, immagine 1 di 1
    • Using a mini Phillips screwdriver, remove two screws by turning them counterclockwise.

  7. Removing Sony Ericsson W350a Keypad: passo 7, immagine 1 di 1
    • Insert an opening tool in the bottom crack between the front and back plates and use a gentle upward pull to separate the back case from the front case.

    • Side buttons/controls may fall from their place in between the back and front casings.

  8. Removing Sony Ericsson W350a Keypad: passo 8, immagine 1 di 1
    • Using a T5 screwdriver, remove the two screws by turning them counterclockwise.

  9. Removing Sony Ericsson W350a Keypad: passo 9, immagine 1 di 2 Removing Sony Ericsson W350a Keypad: passo 9, immagine 2 di 2
    • Using an opening tool and a gentle outward motion, separate the front plate from the inner phone workings.

  10. Removing Sony Ericsson W350a Keypad: passo 10, immagine 1 di 2 Removing Sony Ericsson W350a Keypad: passo 10, immagine 2 di 2
    • Using a Phillips head screwdriver, remove the screw from the front number pad by turning it counterclockwise.

    • Remove the speaker from the phone.

  11. Removing Sony Ericsson W350a Keypad, Keypad: passo 11, immagine 1 di 3 Removing Sony Ericsson W350a Keypad, Keypad: passo 11, immagine 2 di 3 Removing Sony Ericsson W350a Keypad, Keypad: passo 11, immagine 3 di 3
    • After removing the speaker, the keypad will be free to move. If the phone is lying flat on its back, it is connected in the middle right side of the phone. This connection can be seen in the second picture.

    • To remove the keypad, pull gently at the connection until the keypad "pops" off.

    • The third photo in this step will show a closer look at the keypad connection.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Ldellos

Membro da: 03/12/12

112 Reputazione

3 Guide realizzate

Team

Clemson, Team 1-4, Benson Spring 2012 Membro di Clemson, Team 1-4, Benson Spring 2012

CLEM-BENSON-S12S1G4

4 Membri

14 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 1,249