Parti

Nessuna parte richiesta.

Tool on left - PH000 screwdriver
  • Tool on left - PH000 screwdriver

  • Tool on right - iPod fix-it tool

  • Soldering Iron

Aggiungi Commento

Locate the 3 black screws on the bottom of the camera and the 2 gray screws on each side of the camera. Remove them with a PH000 screwdriver.
  • Locate the 3 black screws on the bottom of the camera and the 2 gray screws on each side of the camera. Remove them with a PH000 screwdriver.

Aggiungi Commento

  • Locate the gray band that you removed the screws from; this holds the two halves of the camera together. Use an iPod fix-it tool to pry the gray band loose and remove it.

Aggiungi Commento

  • Use the iPod fix-it tool to separate the back panel from the camera.

Aggiungi Commento

  • Use the iPod fix-it tool to carefully pry the screen from the logic board.

  • There's a ribbon cable that connects the screen to the logic board.

Aggiungi Commento

  • This view shows the ribbon cable that connects to the screen.

Aggiungi Commento

  • Flip the screen down. To disconnect the ribbon cable from the logic board, rock each end of the brown metal retainer that holds the ribbon cable in place until the ribbon disconnects.

Aggiungi Commento

  • Remove the two screws on the top edge of the circuit board to the right of the viewfinder.

Aggiungi Commento

  • To connect the new screen, solder the wires in place and connect the ribbon cable to the logic board.

Aggiungi Commento

  • Unthread the four wires running across the top of the viewfinder from the plastic brackets holding them in place.

Aggiungi Commento

  • Remove the two black screws threaded vertically into the top of the viewfinder. Loosen the flash and circuit board for more accessibility. This will allow for the viewfinder to be replaced.

Aggiungi Commento

  • Remove the small piece of tape holding the four wires to the viewer.

Aggiungi Commento

  • Remove the two screws on the top edge of the circuit board, to the right of the viewer.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Andrew

Membro da: 27/09/2012

7 Reputazione

1 Guida realizzata

Team

Ohio State, Team 1-2, Buehl Fall 2012 Membro di Ohio State, Team 1-2, Buehl Fall 2012

OSU-BUEHL-F12S1G2

3 Membri

3 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 2

Tutti i Tempi: 758