Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Flip the camera so that the bottom is facing you.
-
Take a spare coin and unscrew the battery cover off.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the batteries, making sure to note their proper alignment.
Hi just checking which type of batteries are required? You have two types listed, the SR44/LR44 (I understand those are the same types of batteries) then the CR-1 / 3 /3N 3V battery? How many batteries do I need and which type will I need? thanks!
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove two 4.8mm screws.
-
Remove one 3.4mm screw.
-
Remove one 2.65mm screw.
-
Lift off the back cover.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove three 3.5mm screws.
-
Remove two 3.8mm screws.
-
Remove one 6.35mm screw.
-
Remove one 4mm screw. Lift off the disk.
-
Remove one 5.11mm screw.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove four 4.45mm screws and remove the alignment ring.
-
Remove the interior metal ring and the black plastic ring. Pay attention to the spring's location.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two black stoppers.
-
Using the metal spudger, remove the two triangular hangers.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the metal spudger, peel off the right leather cover.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the metal spudger to remove both the grip cover and the left leather cover.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove two 5.3mm screws.
-
Remove two 5.3mm screws.
-
Remove one 2.35mm screws.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove two 6.65mm screws.
-
Remove two 2.93mm screws.
-
Remove four 5.3mm screws.
-
Remove the black plastic lens holder.
-
Annulla: non ho completato questa guida.
Altre 4 persone hanno completato questa guida.
Un commento
I have Problems to assemble the new black plastic lens holder.
The space between camera Cup and the housing is very low.
Did someone have the same Problems ?