Unisciti alla Community delle riparazioni - Crea un account

Introduzione

PLEASE READ: You'll need a heat gun and a razor blade to remove the tinting. Read and follow all the instructions for the tools you will be using. PLEASE use common sense when using these dangerous tools, and don't cut or burn yourself. Also, ensure you are working in a well-ventilated area in case of fumes.

The vehicle in this guide is a Nissan Altima.

Cosa ti serve

Passo 1 Before Photos

Removing Aftermarket Vehicle Window Tinting, Before Photos: passo 1, immagine 1 di 3

Removing Aftermarket Vehicle Window Tinting, Before Photos: passo 1, immagine 2 di 3

Removing Aftermarket Vehicle Window Tinting, Before Photos: passo 1, immagine 3 di 3

This is what your window will look like before.
And the third photo shows what it will look like after!

Modifica

Passo 2

Roll down the window about 1/4 of the way so you can start to remove the tint from the top.

Modifica

Passo 3

Removing Aftermarket Vehicle Window Tinting: passo 3, immagine 3 di 3

Heat the area with a heat gun at the window's edge.
Start by using the low setting on the heat gun to gradually heat the surface. After the area has warmed up, you can switch to high heat to make it easier to remove the film.
Use the razor blade to peel a small area of the tint film up.

Modifica

Passo 4

Once you've peeled enough with the razor blade to use your fingers, heat the area, then peel with your fingers.
Don't pull with your fingers and heat the area with the gun simultaneously. You'll burn yourself.
Heat the film angling the heat gun up. This will ensure that the film will not rip easily.

Modifica

Passo 5

When you've pulled enough film off so that you don't burn your fingers while simultaneously pulling, use a back-and-forth motion with the heat gun along the area where the film is still on the window while pulling on the film. (See next step)

Modifica

Passo 6

How to heat the area with the heat gun.

Modifica

Passo 7

Once you have removed the film from the top of the window, you can roll up the window.
Continue doing a back-and-forth motion and pulling on the film until all of the film comes off.
If the film rips, no worries. Just continue. You can heat up those sections and remove them later.

Modifica

Passo 8

Once you have removed all of the film, spray the window with glass cleaner and clean the window with either a rag or paper towel.

Modifica

Passo 9

For areas where some residue is still on the window, spray the area with glass cleaner and use the razor blade to scrape the area to remove the residue.
For really tough residue, use Goo Gone in lieu of glass cleaner.

Modifica