RazorX DLX Electric Skateboard Wheel Motor Replacement

Introduzione

This guide is intended to show you how to replace the wheel motor on your RazorX DLX Electric Skateboard. The wheel motor is the main source of power that allows the skateboard to accelerate. Without a properly functioning wheel motor, using the skateboard may become more difficult or unsafe. Before you start, make sure the power button is switched to off.

Cosa ti serve

Passo 1 Battery

RazorX DLX Electric Skateboard Wheel Motor Replacement, Battery: passo 1, immagine 1 di 3

RazorX DLX Electric Skateboard Wheel Motor Replacement, Battery: passo 1, immagine 2 di 3

RazorX DLX Electric Skateboard Wheel Motor Replacement, Battery: passo 1, immagine 3 di 3

Flip the skateboard upside down.
Use a 4 mm Allen key to remove the 25 mm bolt that secures the cover.
Push the cover forward to slide it off.

Modifica

Passo 2

Disconnect the battery and slide it out.
Lithium-ion batteries should not be punctured, heated or improperly disposed of.

Modifica

Passo 3 Control Module

RazorX DLX Electric Skateboard Wheel Motor Replacement, Control Module: passo 3, immagine 1 di 3

RazorX DLX Electric Skateboard Wheel Motor Replacement, Control Module: passo 3, immagine 2 di 3

RazorX DLX Electric Skateboard Wheel Motor Replacement, Control Module: passo 3, immagine 3 di 3

Flip the skateboard back over.
Remove the six 22 mm bolts indicated on the top side of the skateboard with a 3 mm Allen key.
While holding the nut from the underside of the skateboard remove the four 32 mm bolts with the 3 mm Allen key.
Separate the trucks and control module from the board.

Modifica

Passo 4

RazorX DLX Electric Skateboard Wheel Motor Replacement: passo 4, immagine 3 di 3

Remove the four 20 mm bolts using a 4 mm Allen key, then remove the metal plate to separate the motor from the trucks.
Separate the wheel motor from the trucks

Modifica

Passo 5

Remove the two 15 mm Phillips #00 screws to free the motor cable.
Remove the two 15 mm Phillips #00 screws securing the battery cage.
You will still need to remove the standoffs to fully remove the battery cage.

Modifica

Passo 6

RazorX DLX Electric Skateboard Wheel Motor Replacement: passo 6, immagine 3 di 3

Remove the two standoffs holding the battery cage in place with an 8 mm wrench.
The standoffs have a nylon washer on either side of the battery cage.
Lift the battery cage up and out of the control module.

Modifica

Passo 7

RazorX DLX Electric Skateboard Wheel Motor Replacement: passo 7, immagine 3 di 3

Remove the 20 mm Phillips #0 screw.
Disconnect the DC connector. The DC connector can be identified as the connector with only two wires.
Disconnect the power button. It is a temporary switch, which can be identified by its 4-wire configuration.
Disconnect the Hall effect sensor. It can be identified by its 6-wire configuration.
A hall effect sensor is used to tell the board where the motor is in its rotation.
You will need to remove silicone and hot glue to remove the connectors.