Salta al contenuto principale

Introduzione

First step to repairing RIDGID drill. All it takes is getting the case off...

Parti

Nessuna parte specificata.

  1. Remove the backplate. Using a Torx T20 screwdriver, remove the four screws attaching the back plate.
    • Remove the backplate.

    • Using a Torx T20 screwdriver, remove the four screws attaching the back plate.

  2. Kit riparazione batterie MacBook

    A partire da $69.99

    Buy Now

    Kit riparazione batterie MacBook

    A partire da $69.99

    Buy Now
  3. Remove the drill handle.
    • Remove the drill handle.

    • Using the Phillips #2 screwdriver, remove the five screws attaching the drill handle to the body.

  4. Remove the gear casing from the body. Using the Philips #2 screwdriver, remove the four screws attaching the gear casing to the body.
    • Remove the gear casing from the body.

    • Using the Philips #2 screwdriver, remove the four screws attaching the gear casing to the body.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Evan Long

Membro da: 15/04/2010

232 Reputazione

4 Guide realizzate

Team

Cal Poly, Team 15-48, Garner Spring 2010 Membro di Cal Poly, Team 15-48, Garner Spring 2010

CPSU-GARNER-S10S15G48

6 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 5

Tutti i Tempi: 3,719