Introduzione

This guide may be of use if the sound no longer works properly. For speaker accessibility, the battery will have to be removed.

Remove nine 4.8mm screws around the case with a JIS #00 screwdriver.
  • Remove nine 4.8mm screws around the case with a JIS #00 screwdriver.

Aggiungi Commento

Insert plastic opening tool and slide it around the edges until the cover starts to pop off. It may be necessary to go over each side multiple times in order to pop the cover off.
  • Insert plastic opening tool and slide it around the edges until the cover starts to pop off. It may be necessary to go over each side multiple times in order to pop the cover off.

Aggiungi Commento

  • Remove cover completely.

Aggiungi Commento

  • Disconnect battery cable from the motherboard.

Aggiungi Commento

  • Pull the thin black keyboard connector off and set it aside.

Aggiungi Commento

  • Disconnect the thick black band (bus) using a plastic opening tool or fingernail.

Aggiungi Commento

  • Use nylon spudger tool or plastic card to separate battery from the case.

Aggiungi Commento

  • Carefully peel off the battery.

Aggiungi Commento

  • Disconnect the speaker cord from the motherboard.

Aggiungi Commento

  • Use the plastic spudger to slide the speaker out.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Team

IUPUI, Team S3-G2, Harley Spring 2018 Membro di IUPUI, Team S3-G2, Harley Spring 2018

IUPUI-HARLEY-S18S3G2

3 Membri

2 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 6

Tutti i Tempi: 71