Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.
Introduzione
Use this guide to replace the flash card reader in your RCA Lyra X2400.
Cosa ti serve
-
-
Using slight pressure with your finger on the word "OPEN", slide the battery plate down.
-
Remove the battery plate.
-
Place your finger at the bottom of the battery.
-
Lift up on the battery until it pops out from the LYRA X2400.
-
-
-
Remove the two Phillips screws from the silver cover at the top of the Lyra.
-
Slowly wiggle the silver cover while pulling it away from the device.
-
-
-
-
Open the case of the Lyra.
-
Remove the four screws that secure the motherboard to the frame of the Lyra X2400.
-
-
-
Locate the compact flash card slot on the logic board. For assistance on locating this component look at the picture to the left.
-
Use soldering/desoldering tools to remove the compact flash card.
-
Replace compact flash card and use soldering tools to complete the replacement.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Team
Cal Poly, Team 17-3, Regan Spring 2013 Membro di Cal Poly, Team 17-3, Regan Spring 2013
CPSU-REGAN-S13S17G3
4 Membri
8 Guide realizzate
